Leviathan
Leviathan copied to clipboard
MotorDynamicsLab
Leviathan Main Controller for Voron 2 / Trident 3D Printers
Could you please document the amp limit of the rpi connector somewhere? Is it 3a limiting use to rpi 4, or is it 5a allowing for use of an rpi5?
pwm fan
As there is no dedicated port for pwm fan with four pins, i would like to know if it is possible to use PG10 to control my fan ? https://noctua.at/en/nf-f12-industrialppc-24v-3000-sp-ip67-pwm...
My LDO Voron 2.4 kit came with 2 strip LEDs for the chamber light. Their combined current requirement is 580ma @ 24v. The Leviathan has a limit of 350ma (LM3407MY)....
The general selection for fans in 12v is much better than with 24v. Other contemporary boards support 12v fans. Leviathan should too.
https://github.com/MotorDynamicsLab/Leviathan/blob/master/Klipper_config/trident_leviathan_v1.2.cfg I get setting it to -10,-10 to "force" a user to set the value, but honestly, why not 150,150 as a default? Or, at least change the wording in...
When the tachometer pin on a 5 volt 3 wire Delta axial fan is used with any of the fan ports, it results in the fan shutting off instead of...
are there any other users of this board on here, i have put bootloader and firmware on but cant connect to any external can modules. is there a original bootloader...
The Pi Hat adapter schematics and Ki Cad files are not currently in the Repo. Could we please get access too them, I'm particularly interested in the fuse and capacitor...
The Leviathan has a SWD header with a RESET pin exposed. In theory, it should be possible to flash the bootloader *and* firmware to the Leviathan from a Pi4/5 using...
For reasons unknown to me I can no longer switch to DFU mode. The Levithan is installed in a working printer and no other USB devices are connected Here is...
Metadata
Owner
Metadata
Leviathan Main Controller for Voron 2 / Trident 3D Printers