antsdr-fw
antsdr-fw copied to clipboard
MicroPhase
ANTSDR Firmware
I wonder if there are any instructions documenting how to build the SD Image from the zip file located in the [releases](https://github.com/MicroPhase/antsdr-fw/releases) folder? Also I would like to know which...
Dear sir, I am trying to use ANTSDR-E310 as a front-end for GPS signal to acquire GPS signal in real time. Any help on this?
With a sample rate of 1.92 Mhz I see that I'm loosing samples. Any recommendation about Ethernet configuration or other? Than you!
When using gnuradio, the sample rate cannot be set above 5MSPS, otherwise the waveform is not right.  corresponding diagram:  When the sample...
i follow the tutorial, build the lastest source code, and set the jumper into Flash Boot mode, update the u-boot and kernel successfuly. when i try to modify u-boot code,...
hi, Q1: I want to using command 'tftpboot' for loading my operating system( not linux ), and modify file zynq_zc70x.h like: ``` #ifndef __CONFIG_ZYNQ_ZC70X_H #define __CONFIG_ZYNQ_ZC70X_H #define CONFIG_ZYNQ_I2C0 #define CONFIG_ZYNQ_EEPROM...
I have downloaded the 2019 xilinx sdk and installed like the tutorial instructs. But says nothing on what to do about the licensing process with the zynq7020. Was told there...
I download E310 latest firmware, 1.00 from https://github.com/MicroPhase/antsdr-fw/releases/download/e310_v1.0/sd_image.zip but after copying to sd-card and reboot. The system show "b220_v1.0-3-g8cf9" is it should be e310..... ? Regards. 
question:I run the Capture RF Data to Baseband File Using ADALM-PLUTO Radio example with matlab 2022b configurePlutoRadio('AD9364') is error "Reference to a field that does not exist 'SerialNum' " ...
I have a MicroPhase ANTSDR E310 with latest firmware (e310_v1.2-dirty) . When I tried to use ANTSDR E310 with MATLAB 2022a, I get the following error > dev = sdrdev('AD936x');...
