LeoSum8

Thank you @tobiasguyer for the fork and @playduck for the detailed steps. However I can't complete the build as I am running into errors when following the steps in https://github.com/feelfreelinux/cspot/issues/156#issuecomment-1866629464...

Hi, and thanks for answering! The dependencies are installed. Thanks to your CMakeLists.txt files which I copied the pre-building errors during set-target command went away. However building still fails with...

So e.g. this one would work out of the box? https://www.ebay.de/itm/285834564622 Do you have some more documentation on how you hooked it up?

Thank you so much for all the details! I ordered the board. When it arrives, I will try to set it up. While doing so, I could add to this...

Out of curiosity: Why do you want to go with the W5500 instead of lan8720 if you don't have one laying around already? :) My lan8720 has not yet arrived...

> @LeoSum8 Here goes the pinout for LAN8720: > ... > > Also my PHYs LED1 pin is pulled low through a LED + resistor and MDIO is pulled high...

> @LeoSum8 ... My EspLouder has PinHoles matching the W5500-Boards so no need for much diy. So you must have Rev. E then. I just checked, mine are D without...

Thank you so much for holding my hand here! Of course I have a soldering iron. I even have soldering tin! :P So I followed PIN2 (nREFCLOCKO_EN) and PIN15 (nRST)...

I think I have this board, or at least a clone of it: https://www.waveshare.com/lan8720-eth-board.htm So the schematics would be these: https://www.waveshare.com/w/upload/0/08/LAN8720-ETH-Board-Schematic.pdf  And indeed it looks like nRST is going...

So this hardware mod would need to be combined with the code changes you described above > your only option will be to provide MAC clock from ESP32 --> to...