FSR_Endstop

FSR_Endstop copied to clipboard

I have four fsr's set up on a flat surface w/ a flat glass plate on top of them and I'm running 2 sets of 2 ea fsr connected in...

inventabuild

another iteration of your idea: https://github.com/random-builder/toucher please let me know if you have any thoughts

Andrei-Pozolotin

So far the best way I can figure to do this is using the 3 fsr pads under the bed using a maximum equilateral triangle solution or just inside the...

mshievitz

Thermistor inputs to standard endstop inputs

1

You mentioned the following in your README file. "Johann's original branch used one of the thermister inputs, but he later changed to using one of the standard endstop inputs" Why...

rajanjamu

After tracking down why my bed was never leveling quite right, I found one of my FSR sensors was damaged (small crack running across a surface wire on one sensor)....

ghost

using the board with external 5v source

3

Hi, I would like to use this board with an external 5v source, then somehow connect it to the 2 pins of the z probe input on my printer. is...

paboman

John - Does it make sense to add a "trigger debounce" feature that will discard subsequent triggers if they happen very quickly after the first? I am thinking this could...

Verohomie

Support multi-sensor FSR. For square beds better to have 4 sensors.

Drakelive