Galileo2
Galileo2 copied to clipboard
JaredC01
In one of the interviews about Galileo2 I've heard, as far as I remember, that if should be printable using 0.6 nozzle and carbon fiber filament. And it almost can....
Sorry if this is being tracked else where, but is there a plan to include a hall effect sensor in the body?
There is no information anywhere in the G2SA assembly manual that a piece of PTFE should even be installed, let alone how much should be sticking up out of the...
Howdy! the g 2sa tensioner screw seems to not hold itself on the arm and will fall off the arm itself maybe some thin slots that cup around the sides...
Why is the Galileo2_extruder designed with a single-sided meshing gear clamping the Filament, which often causes my extruder to slip. I also tried tightening the clamping screws, but this would...
I have a slightly scratchy squeaking noise when the Z axis is shutting down, what could that be? I took note of the shims in the planetary gear, which are...
Hi there! I recently upgraded to an Galileo 2 extruder on a ldo voron 2.4. Since then I lost 5-7 mm on x since the cable chains are hitting the...
Have there been any major changes to G2E since the beta? Thanks for the official public release!
hi @jlas1 SB2209/SB240 can male connector interfere with PG7 this is because bigtech can female connector is top mount while SB Toolhead PCB, FLY-SB-2040 one is back mount 
