Marlin

Marlin copied to clipboard

CR10S Pro V2 bleeding and 2.0 Y is reversed causing bed homing issue also wav Sound is Creepy

2

### Description When setting up bed levelling, the Y axis tries to home with the switches, but moves forward instead. The machine's switch is located at the rear of the...

oioiandy

CR-10S Pro V2 - Weird sounds in the menu, even with usual .wav files

3

### Description DW7.4.7 for CR-10S Pro v2 seems to be a bit off, the sound used in the menu are really weird like 3 seconds of a song, instead of...

Fabriziooo1

CR-10S PRO V2 the cooling button does not start the fan

1

### Description Hi, I have a CR-10S PRO V2, I see a bug since I switched to Tinymachines3d firmware, unless I do the flashing wrong. When I click on the...

Grillons2

CR10 (not even a little) Smart screen firmware compatibility issue?

3

I have a CR10 Smart with V2.5 S1 board. Board flashes fine with firmware_CR10Smart_64kBL_DW7.4.7.bin and screen is flashed with dwin_set in CR10SmartDwinTM3D_V8.7z... The issue presents when starting the printer: it...

pFallenAngelq

### Requirements * Filling out this template is required. Pull Requests without a clear description may be closed at the maintainers' discretion. ### Description ### Benefits ### Configurations ### Related...

enav12

### Description of Bug Installed firmware for my Ender 6, whenever I begin a print it heats up normally, homes x y to center and says "ENDSTOPS P" then autohomes...

Schizzr

CombinedLandscapeDwin_TM3D_V8 DWprj.hmi

4

I'm using CombinedLandscapeDwin_TM3D_V8.7z for my CR-10s Pro V1 and I would like to have the V8 DGUS project if possible. The V7 version was available previously and I edited that...

Ericvf

Feature request: Creality CR-200B support

7

Add support for Creality CR-200B enclosed 3d printer

mcecchi

Support for Creality CR-10 SE

1

Does it support Creality CR-10 SE? I've been looking for some reports, but so far I have no confirmation. I believe that the Marlin website has the CR-10 SE plate,...

fbrunosf

Ender 6 moving to front after stop print

10

### Description If I stop the print while printing the extruder will move to the front then left hitting the frame. Home position should be back and right. ### Steps...

justinkumpe