Enraged-Rabbit-Community
The Toolhead Sensor-only EBB CW2 Body STL should be paired with EBB Cable Cover
The SB_CW2_Body_EBB.stl does not fit the standard cable cover. ~As this is a nice option for a lot of stealthburner PCBs, it might make the most sense to just provide a link to or a copy of the BTT cable cover for EBB in this repo that fits this specific design.~ EDIT: I've now printed all of the ones on the BTT repo for EBB to test, and I can't find one that actually fits the EBB body accurately. The one I previously linked is about 5mm too tall, and the current one is rounded by the ECAS, leaving a bit of a gap. It seems that perhaps there's not a good, current cable body STL for this part?
This is an issue as users may casually decide to just go with a single sensor, and it is not obvious if you aren't initiated on what "EBB" might refer to that you need an alternative cable cover to fit this design.
