ERCF_v2

ERCF_v2 copied to clipboard

2020 mounting parts

9

Please make cuts in the 2020 mounting parts for the T-Nuts. The parts dont hold in the 2020 extrusion. wrong  ok: ![2023-12-26 14_53_41-SturdyBunnyProject_Study_FeederV2...

Anollya

accelarate -> accelerate

eltociear

Is this intentional? There's a single layer space between beed and the rabbit figure in the Support Arm file. 

mszulen

Piece of filament labeled "M" should be "P"

D20180

**Supports/EASY-BRD/[a]_ERCF_Easy_Brd_Bracket_Bottom.stl** Part is missing the built-in support material in the repo 

EllaFoxo

Gneu42 Block End mod issue

3

@gneu42 I think in your `Filament_Block_End.stl` from your Reinforced Block End Mod the two little conicals holes are missing? 

Benoitone

[ERF][Toolhead_Modifications] Port CW2 Main Bodys from CW2 motor plate RC1 to Release Version

20

This PR applies changes done to the CW2 motor plate from RC1 to Release version to all Clockwork2 main bodys.  Additonally adds a M6 bowden fitting version of the...

EmJay276

[ERF] StealthOrbiter Extruder

1

Add support for StealthOrbiter Extruder - currently under testing!

EmJay276

Filametrix cutter for Crazy Dragon. Accounts for changes to Stealthburner, since the original mod was made for RC1, adding Tap support in the process.

EllaFoxo

Request to add XOL cutter+sensor

5

Hi, I know it's only been released, but are there any plans on adding cutter and/or filament sensor to XOLs current build (current build isn't XOL2 by the way): https://github.com/Armchair-Engineering/Xol-Toolhead/tree/main...

fryc88