DccPlusPlus
Return -1
Hi, first thanks for that cool project. I bought an ardolino uno, a ardolino standard shield, and use jmri. Within 2 days all woks fine except the programming Read cv I have 16 volt dc, and i can program any cv. But when i want to read at the programmtrack. The motor ist moving sime milimeter. But i get back -1 no reply. It is mo contact problem as i connected the lok with krokodiles. I used the master ardulino software. Can anybody give me a hint
Hi, i went on but did not solve the issue.
When i send <R 1 123 123> In the ardolino stetch i also get back -1
And the power at a1 does not change dc or ac. Voltage. The lok is jumping.
I opened the 2 brak bridges and the voltage bridge.
Can now anybody help me please
Regards Frank
Franky,
I haven't been following your current project but I built several Uno and Mega DCC++ systems.
I've never cut the break point on the back of any of my DC motor shields. Does the project your working on require you to do this.? If not, try a simple test and reconnect the break by either re-soldering or tape wire across the point to close the connection. Leave the VIN point cut or open.
Reassemble and test the code as is.
Regards, Kevin
----- Original Message -----
From: "Franky1265" [email protected] To: "DccPlusPlus/BaseStation" [email protected] Cc: "Subscribed" [email protected] Sent: Friday, February 7, 2020 4:58:54 PM Subject: Re: [DccPlusPlus/BaseStation] Return -1 (#49)
Hi, i went on but did not solve the issue. When i send <R 1 123 123> In the ardolino stetch i also get back -1 And the power at a1 does not change dc or ac. Voltage. The lok is jumping. I opened the 2 brak bridges and the voltage bridge. Can now anybody help me please Regards Frank
— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub , or unsubscribe .
Hi Kevin, My project is just running dcc at HO I connected the 2 break point again, Still the same, all works except the reading cv I tried Lenz silver esu lp 2 and 4 at least the lenz lok is jumping
Does anybody know how the voltage at A1 is moving when i resd cv. Is it measurable wit a normal voltmeter, is it dc or ac,
So, i looked a0 there dc is increasing till 1,4 volt . When droving. At a1 i see no milivolt even no flipping with the osziloskop. The parrot is dead. I come back when i changed it
Me again, the motorshield was defect. Now it works. And a1 is flippind with a 5 euro multimeter to 0,2 volt dc when i read cvs
Franky, Congratulations, Good Job finding the problem. Enjoy DCC++ Kevin
----- Original Message -----
From: "Franky1265" [email protected] To: "DccPlusPlus/BaseStation" [email protected] Cc: "Kcsmith0708" [email protected], "Comment" [email protected] Sent: Wednesday, February 12, 2020 4:10:28 PM Subject: Re: [DccPlusPlus/BaseStation] Return -1 (#49)
Me again, the motorshield was defect. Now it works. And a1 is flippind with a 5 euro multimeter to 0,2 volt dc when i read cvs
— You are receiving this because you commented. Reply to this email directly, view it on GitHub , or unsubscribe .