grblForCyclone

grblForCyclone copied to clipboard

Endstops and probe not functioning

2

When homing is enabled and it's given a new strategy (z then x+y for example) the axis crashes into the switch at high speed. If I invert endstop pins in...

ghost

Servo support

5

Hi Carlos, I am using your firmware for my school project, for our Z-axis we want to use a 9g servo to move the pen up and down. Is there...

Niekvdplas

RAMPS 1.4 Extruders / dual axis motors

4

Hi, is it possible to configure the RAMPS 1.4 with your firmware to duplicate the output of motor X to E0 and motor Y to E1? Just like on Marlin...

raenji-sk

CarlosGS