smoochiee板故障

Open Liat583 opened this issue 3 months ago • 3 comments

I purchased its PCB board and soldered it to connect the data cable before flashing the firmware. However, Windows did show that it could not recognize USB devices. When I successfully burned the firmware using the TTL programmer, the screen displayed booing The rear screen is black, but there are signs of it turning off, indicating that the program is not faulty Just the screen doesn't display the interface

Nov 12 '25 15:11 Liat583

My Bruce can run normally

Nov 16 '25 08:11 Liat583

are you using chinese gnd-vcc esp32 ? if you do maybe it needs additional driver : https://github.com/vcc-gnd/YD-ESP32-S3 or install yours driver.

Nov 21 '25 12:11 maruf009sultan

Thanks> are you using chinese gnd-vcc esp32 ? if you do maybe it needs additional driver : https://github.com/vcc-gnd/YD-ESP32-S3 or install yours driver.

Nov 21 '25 12:11 Liat583