BU-hammerTeam
Fine Tune PyHammer So that Results File Shows Best Fit
Take the simple case of four FITS files under template A3_-05_Dwarf.
Run PyHammer against them. Notice they are not reported as A3_-05.
Visually tune each file to A3_-05 and notice the smaller Template Match Metric for each as best match.
PyHammer should be tuned to do this by default, for each template.
Whatever logic PyHammer is using to create the Results file, it is not selecting the best match, based on the lowest Template Match Metric. At a minimum, PyHammer should report the FITS files that make up a template, as matching the template in question and the associated metallicity.
This is really needed for processing a large group of FITS files, where we are relying on the accuracy of the Results file, and where visually tuning is not an option.
I will say that the Template Match Metric was never intended for robust matching. It is simply a rough calculation which finds the "distance" between your spectra and one of the templates. The full algorithm performs redshift corrections and matches based on specific spectral features and lines.
I do have to wonder though if the spectra you chose are representative of how well the algorithm as a whole can work. It certainly is interesting that files which made up the templates are not then matched to the template they should, but PyHammer does have a certain amount of error to it (as any process would) and I don't think there's much "fine-tuning" one could do to fix that, without changing the algorithm completely.
I will be doing some testing today and will report back about the Template Match Metric
Seeing similar results across other PyHammer templates. Guessing Hammer was used to classify the template FITS files, that PyHammer uses, but PyHammer doesn't always classify the template FITS files the same way. See attached G0_-05_Dwarf_PyHammerResults as an example:
