Print-Tuning-Guide

Print-Tuning-Guide copied to clipboard

FR: hope we can include in the pressure advance lines method a bed for delta printers

7

hope there is an option to change the bed shape to circle for our delta printers https://realdeuce.github.io/Voron/PA/pressure_advance.html

jpbnto

TEST_SPEED macro not compatible with latest klipper

3

Due to the Klipper change from ACCEL_TO_DECEL to minimum_cruise_ratio, the TEST_SPEED macro fails halfways through with error `Error on 'SET_VELOCITY_LIMIT VELOCITY=600.0 ACCEL=16000.0 ACCEL_TO_DECEL=': unable to parse `.

Arakon

Question about SuperSlicer version

3

Hello, In provided profiles is "Required SuperSlicer version: [📄2.4.58.5](https://github.com/supermerill/SuperSlicer/releases/tag/2.4.58.5)" but I wonder if I update the SuperSlicer to the latest version? Is it mandatory to use 2.4.58.5?

Terixxx

Update TEST_SPEED.cfg

1

Klipper no longer has a MAX_ACCEL_TO_DECEL paramter in the firmware, it has been changed to MINIMUM CRUISE RATIO. This is a patch that works for now.

SuhbatDaRobot

There is an Error in the calculation of the new_rotation_distance in the Tuning Chapter Extruder Calibration

2

 Hey, I think there must be an error in the calculation of the new rotation distance. There is a difference between the calculations of Klipper Marlin and...

iTzMtrx

Ellis' Print Tuning Guide compatibility?

4

Is the guide compatible with Ender-3 V3 KE ? First step of calibration "Open your printer.cfg and find the [extruder] section." is this in the printer software, or??? I find...

cwadej

TEST_SPEED Macro Move out of range

10

Wondering if having to do with sensorless homing, but get an error `Move out of range` when trying to run `TEST_SPEED` macro. `TEST_SPEED ACCEL=5000 ITERATIONS=2 7:12 PM TEST_SPEED: starting 2...

seanmccully

Add clarification about "not connected top infill" in prusaslicer. Turns out, it is supported after all. It's called "Monotonic lines". It does improve small area extrusion a bit on the...

vicwomg

TEST_SPEED Sending X Axis past Set Maximum

15

When using TEST_SPEED after the initial homing of axis the macro will move Y to 214 (215 is configured max in printer.cfg) and then the macro attempts to send X...

bailboy91

I am running heavily modded cr10s. KLipper over RBP, dual gear metal extruder, volcano 3 hotend with cht nozzle, 80w heater, 700W heated bed, anti backslash nuts on z lead...

bmharon