Cylindric Custom Supports

Open Psyc0Flyer opened this issue 3 years ago • 1 comments

I have noticed that while using the cylindric custom support plugin, after I place a few support shapes, my print time goes CRAZY high and after checking my Z height # between layers, it has gone from the .2 I normally slice at to a .12 O_)o. Grant it the prints look AMAZING BUT.. A print that should normally be 4hrs is 15! I am using the custom shapes as "blockers" for fuzzy skin so I only have fuzzy skin where I want it and not where parts get connected together.

Oct 25 '22 07:10 Psyc0Flyer

I don't think this problem is related to this plugin. The only change the plugin makes is to change the Support type parameter to "EveryWhere". So it's certainly a problem of bad manipulation. Unless you can reproduce this issue.

Oct 25 '22 17:10 5axes